accessible_forward
Accessibility Statement. Read more.
2008 DEWALT DW744X AND DW744XC 10 INCH JOB SITE TABLE SAW
SAFETY RECALL NOTICE
IMPORTANT SAFETY RECALL
DEWALT DW744X and DW744XC – 10" Job Site Table Saw
It is possible for the pivot bracket to separate. This can cause mis-alignment between the blade and the fence, posing a kick-back hazard.
The following products are affected:
| Model Number | Description | Date Code |
| DW744X | 10" Job Site Table Saw | 2007 15 through 2007 40 |
| DW744XC | 10" Job Site Table Saw and DW367 7-1/4" Circular Saw | 2007 15 through 2007 40 |
ONLY TABLE SAWS WITH THE MODEL NUMBERS AND DATE CODES LISTED ABOVE ARE AFFECTED
The location of the model number and date code are shown on the photography below. Products stamped with an "X" following the date code are not affected.
If your table saw is affected, STOP USING IT IMMEDIATELY, and call DEWALT toll-free: 1-888-742-9178 between 8:00 AM – 5:00 PM Eastern Time Monday through Friday.
www.DEWALT.com
for the location of a service center to obtain a replacement table saw.
Recall done in cooperation with U.S. Consumer Product Safety Commission 04/08 DW744XRP
Post Until September 1, 2008